DIY Tips for J.E. Shekell Home Repairs

Are you in need of home repairs or maintenance in Evansville, IN, Henderson, KY, Princeton, IN, Vincennes, IN or Newburgh, IN? J.E. Shekell has the expertise and tools to get the job done. But if you’re looking for ways to handle home repairs yourself, here are some helpful DIY tips.

Furnace Replacement

When it comes to replacing your furnace, it’s best to call in an expert, as it is an extremely complex job. But if you’re feeling ambitious, you can start by turning off the power to the unit. Then, remove the old furnace and bring in the new one. Make sure to follow manufacturer instructions for proper installation. After the new furnace is in place, you’ll need to hook up the power, water and gas lines. Finally, make sure the area around the furnace is well-ventilated and sealed.

Heating Repair

If you’re having trouble with your heater, try checking the thermostat first. If it’s set too low, the heater won’t come on. Make sure the thermostat is set correctly, then check for any obstructions blocking the flow of air. If the filter is clogged, replace it and make sure all vents are open and clear. If the problem persists, you’ll want to call in a professional.

Plumbing Repair

If you’re having trouble with your home’s plumbing, start by inspecting the pipes for leaks and blockages. If you spot a leak, you’ll need to replace the pipe. If the pipes are blocked, try using a plunger or auger to unclog them. If you can’t solve the issue yourself, it’s time to call in a professional.

AC Repair

If your air conditioner isn’t working properly, start by checking the thermostat. Make sure it’s set to cool and the temperature is low enough for it to kick on. Then, check the air filter to make sure it’s clean and clear. If the filter is dirty or clogged, replace it. If the problem persists, you’ll want to call in an expert.

Electrical Repair

When it comes to electrical repairs, it’s best to call in an expert. That said, if you’re feeling brave, there are a few basic repairs you can try. Start by checking your circuit breaker. If it’s tripped, reset it. If that doesn’t work, you can try replacing the fuse. If that doesn’t work, you’ll need to call in an expert.

DIY home repairs can be tricky, so it’s always best to call in an expert if you’re having trouble. J.E. Shekell has the expertise and tools to get the job done. But if you’re feeling brave, these DIY tips should help you get the job done. For more tips on home repairs, check out this DIY Home Repair Guide.

About the Author

Leave a Reply

Your email address will not be published. Required fields are marked *

You may also like these